Cylinder maintenance protection

Jun 20, 2016

Leave a message

And welding method. When the cylinder is larger, measuring crack at the last position for the adoption of this law fixes. Attention is cracked at both ends before welding crack drill holes, drive v-Groove before welding and welding with oxygen. Calcium carbide arrogance is cracked at both ends "heating", that shrinkage.

Second, plugging method when the cylinder and the rest position with crack, trachoma, fluffy and so on shortcomings, cylinder leak plugging up. The lOOg sealant into the cylinder head from the water, installed the thermostat, and fill it with water, and export the 0.3MPa high pressure atmosphere cooling systems to increase the water pressure, so full of water plugging Agent sets the gap to facilitate adhesive bonding. 3--5 day for launching plugging agent of landfill leachate and inject water. Crack repair hydrostatic test should be carried out. When testing, cylinder liner, cylinder head fitted on hydraulic experiment platform, is when the water pressure is 0.3--0.4MPa, maintenance of 5min any leakage, that is fine.

Third, fill the plate. When the stereo position when there is a crack in the cylinder body for the adoption of this law fixes. Approach is to crack shaved about 3mm, then fiberglass and steel plate coating epoxy resin adhesive, in turn pasted crack plane location and tapping the fingerprint, and then fixed with M6 screws.

When the four, unconditional for the adoption of vehicle test method. Remove the water tank and the water pipes and on the oil pan, high-pressure air tube in a heat pipe are pulled out, top, water seal. Then pump into the 0.4MPa high pressure atmosphere experiment, there should not be any leakage after 5min scene.


Send Inquiry